Steel City 40260H, Руководство пользователя

Страница: 18 / 43

GEARBOX SHAFT KNOB ASSEMBLY
Assembl
e
the knob on to the shaft
shown in
Fig 7 .
Fig. 7
EXTENSION TABLES
The extension table s support the workpiece as it enters
and exits the planer.
1. To mount the extension tables, thread three M8 x
20mm set screws into the bottom holes of the
extension table. Only screw them in about 1/3 of the
way for now.
2. Using three M8 x 25mm hex head mounting bolts,
mount one extension table to the main table.
SEE FIG 8.
Fig. 8
3. Place a straight edge on the main table so that it lies
flat on the table and extends out over the extension
table.
SEE FIG 9.
Fig. 9
4. Adjust the three set screws until edge of the exten-
sion table that is the furthest away from the main
table is even with the straight edge. Please note that
it may take several combinations of loosening and/or
tightening the set screws and mounting bolts to get
the extension table level with the main table.
5. Repeat steps 1-4 to attach the other extension table
to the other side of the main table.
18