Steel City 40260H, Руководство пользователя

Страница: 25 / 43

BELTS
Fig. 23
MAKE CERTAIN THE MACHINE IS DISCONNECT-
ED FROM THE POWER SOURCE
SEE FIG 23
1. If the belt is too loose, remove the belt guard using
the two threaded knobs.
2. To check belt tension, squeeze the Belts at their
midpoint with moderate finger pressure. You should
be able to deflect each belt no more than 3/4
3. Remove the panel at the back of the machine stand
to access the motor assembly.
4. The motor pivots on a platform suspended at one
end by two threaded adjustment bolts. Adjust the
locknuts (A) up or down the shafts until the desired
belt deflection is achieved.
.
".
WARNING
!
GEAR BOX
The gearbox is located just behind the handwheel on
the right side of the planer. The gearbox transfers
power from the belt driven cutterhead to the power
feed rollers. It has a two speed transmission that is
controlled by a lever on the right side of the planer.
When it is engaged, the power feed rollers will move
the workpiece through the planer at either 16 ft/ min or
30 ft/min. The center position on the lever is neutral.
1. To inspect gearbox, loosen the socket head cap
screw on the gearbox cover.
2. Pull the cover off the roll pins that hold it in place
There are two metal guard plates bolted to the
backside of the gear box cover. It may be necessary to
remove one of these guards in order to remove the
gear box cover.
3. Inspect the bolts that hold the sprockets in place
4. Check the drive chains to make sure that the
retaining clips are in place.
NOTE:
SEE FIG 24.
Fig. 24
25
A
B