Steel City 35600, Руководство пользователя

Страница: 27 / 44

27
1. The miter gauge has adjustable positive stops at
0-degree and plus or minus 45-degrees or it can be
manually set at any angle between plus or minus
60-degrees.
2. To rotate miter gauge body (A), loosen knob (B)
and pull out plunger (C) and rotate miter gauge
body to desired angle and tighten knob.
SEE FIG. 29.
3. To rotate to the next positive stop, pull plunger (C)
out, rotate miter gauge body then push plunger
back in and continue rotating miter gauge body until
it stops against next positive stop.
MITER GAUGE ADJUSTMENT
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
Fig. 29
Fig. 30
B
C
A
D
E
ADJUSTING POSITIVE STOPS
WARNING
!
1. To adjust 0-degree positive stops, loosen knob (B),
pull out on plunger (C) and turn miter gauge over.
2. Loosen the lock nut (D) 3 or 4 turns. SEE FIG. 30.
3. Place a square against the guide bar and front of
the miter gauge body. Square the miter gauge
body to the guide bar and tighten knob.
4. Push in plunger and make adjustments to stop
screw (E) so that it touches the plunger and tighten
lock nut.
5. Recheck the positive stop angle to the saw blade.
Insert the guide bar into the miter slot and slide the
miter gauge up to the saw blade.
6. To check, place a square against the saw blade
and miter gauge body. If any more adjustments are
needed repeat steps above.
7. To set both 45-degree positive stops, repeat steps
1 thru 6 above at the 45-degree settings.