Steel City 35600, Руководство пользователя

Страница: 29 / 44

29
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
ALWAYS wear eye protection. Any machine can
throw debris into the eyes during operations, which
could cause severe and permanent eye damage.
Everyday eyeglasses are
NOT safety glasses.
ALWAYS wear Safety Goggles (that comply with
ANSI standard Z87.1) when operating power tools.
The following section was designed to give
instructions on the basic operations of this table
saw. However, it is in no way comprehensive of
every table saw application. It is strongly recom-
mended that you read books, trade magazines, or
get formal training to maximize the potential of
your table saw and to minimize the risks.
Before you begin to use your Table Saw, you should
give it a thorough inspection, making sure you ask
yourself the following questions:
1. Is the blade mounted correctly?
2. Is the saw stable?
3. Is it wired properly?
4. Is the electrical system properly configured?
5. Haved you checked your workpiece for obvious
defects?
6. Is the guard assembly installed and functional?
7. Have you checked the saw blade clearance when it
is adjusted to varying angles and depths?
8. Have you read all the warnings and directions
regarding the operation of this machine?
TEST RUN
1. Face the table saw and stand to the left of the
blade path.
2. With one finger on the ON button and one
finger on the OFF button, turn the saw on.
Be ready to turn the saw off in case of a mishap.
3. Watch and listen to the saw. Note whether there are
any unusual sounds or excessive vibrations.
4. If anything appears abnormal, immediately turn
off the saw, unplug it, and fix the problems. If a
problem exists that is beyond the scope of this
manual, contact your dealer.
5. If the saw is operating properly, turn it off and pre-
pare to make a cut according to the instructions
outlined in this section.
ALWAYS
wear a NIOSH/OSHA approved dust mask
to prevent inhaling dangerous dust or airborne
particles.
WARNING
!
WARNING
!
WARNING
!
WARNING
!
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
WARNING
!
PRE-RUN CHECK