Steel City 35600, Руководство пользователя

Страница: 18 / 44

18
Fig. 3
Fig. 4
D
E
C
1. Place one of the handwheels (A) onto the blade
raise/lower shaft (B) located on the front of the
cabinet. Align the groove (C) in the back of the
handwheel with the pin (D).
SEE FIG. 5.
Fig. 5
Fig. 6
C
B
D
A
E
HANDWHEEL ASSEMBLY
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
WARNING
!
2. Thread the locking knob (E) onto the threaded end
of the shaft.
SEE FIG. 6.
3. Repeat the steps above to assemble the remaining
handwheel and locking knob onto the bevel shaft
located on the side of the cabinet.
1. Before installing the extension wings on the table
saw, thread the four M6 X 15mm set screws (A) into
the threaded holes in the wings. Only screw them
in about 1/3 of the way for now.
SEE FIG. 3.
B
A
4. Adjust the four set screws (A) until the edge of the
extension wing that is furthest away from the main
table is even with the straight edge.
NOTE:
It may take several combinations of loosening
and/or tightening the set screws and mounting screws
to get the extension wing level with the main table.
5. Repeat steps 1 through 4 for the remaining exten-
sion wing.
2. Using the four M8 X 30mm hex head mounting
screws, four M8 lock washers, and four M8 flat
washers (B), mount one extension wing to the main
table.
3. Lay a straight edge or level (C) across the saw table
(D) and extension wing (E). Make sure that the
front face of the extension wing is flat to the front
face of the saw table. Adjust the extension wing so
that its top surface is exactly flat to the saw table
and securely tighten hardware.
SEE FIG. 4.