Steel City 35600, Руководство пользователя

Страница: 17 / 44

17
ASSEMBLY
• The table saw is a heavy machine; two people may
be required for certain assembly operations.
•
DO NOT
assemble the table saw until you are sure
the tool is unplugged.
•
DO NOT
assemble the table saw until you are sure
the power switch is in the “OFF” position.
• For your own safety,
DO NOT
connect the machine to
the power source until the machine is completely
assembled and you read and understand this entire
User Manual.
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
DUST PORT ASSEMBLY
Fig. 1
1. Attach the dust port (A) to the opening in the
bottom rear of the cabinet with four 1/4-20 x 1/2”
round head tap screws.
SEE FIG. 1.
A
POLY-V BELT ASSEMBLY
1. Make sure all packaging material has been
removed from inside the cabinet.
2. Open the motor cover and place the motor Poly-V
belt (A) over the blade pulley (B).
SEE FIG. 2.
3. Carefully lift the motor (C) and place the belt under
the motor pulley (not shown). Make sure all the
v-notches in the belt are mated with the v-notches
of the blade pulley and motor pulley.
4. Carefully let the motor down and close motor cover.
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
Fig. 2
EXTENSION WING ASSEMBLY
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
CAUTION: The extension wings are heavy; two people
are required to assemble both extension wings to the
table saw.
C
A
B
INSTALLATION AND LEVELING
Final location for the saw must be level, dry, well light-
ed, and have enough room to allow movement around
the saw with long pieces of wood stock.
Level the saw front to back and side to side, using a
carpenter’s level placed on the table. Use shims under
the corners, if necessary, but make sure the saw is
stable before being placed into service.
WARNING
!
WARNING
!
WARNING
!
WARNING
!