Steel City 35600, Руководство пользователя

Страница: 24 / 44

24
Fig. 21
E
6. Rotate the saw blade back so that you take the
measurement from the same spot on the saw
blade.
SEE FIG. 21.
7. Take a reading at the rear of the blade (E) with the
combination square. If there is a difference of more
than .010 between the rule and the blade, then an
adjustment will have to be made.
8. If an adjustment is necessary, see “ADJUSTING
BLADE ALIGNMENT.”
ADJUSTING BLADE ALIGNMENT
NOTICE:
Blade alignment is factory set and should not
need adjustment. All saw blades have some runout.
Therefore, readjusting the blade alignment should only
be attempted if it becomes necessary (see “CHECKING
BLADE ALIGNMENT”).
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
Fig. 22
A
B
1. To align the blade parallel to the miter slot, first
loosen two hex head screws (A) under the left side
of the table saw. This is the same side as the bevel
handwheel (B).
SEE FIG. 22.
2. Open motor cover located on the right side of the
table saw. Loosen two hex head screws (C) located
directly above the opening.
SEE FIG. 23.
3. The saw table is now loose and can be reposi-
tioned until the blade is parallel to the miter slot.
Repeat steps in “CHECKING BLADE ALIGNMENT.”
4. When blade is parallel to miter slot, tighten all four
hex head screws.
5. Recheck blade alignment.
6. Tilt the blade to 45 degrees, and rotate the saw
blade by hand. Make sure the blade does not
contact the table insert.
Fig. 23
C
C
WARNING
!