Steca Solarix 2020-x2, Инструкция по установке и эксплуатации

Страница: 6 / 23

EN Description
6 751.792 | Z01 | 1504
When only one battery is used then this must be connected to
the main battery terminals.
The charging times depend on the power provided by the solar
module and the capacity of the battery.
With a maximum load current of 20 A the load circuit is suitable
for external appliances with a power rating of up to 240 W at
12 V and 480 W at 24 V.
The solar charge controller begins operating as soon as a battery
is connected. If the solar module delivers no voltage for more
than 48 hours, the solar charge controller will enter hibernation
mode (all LEDs are deactivated). When a voltage is delivered
again by the solar module, the charge controller will resume
functioning again within 30 minutes.
The user does not need to operate the solar charge controller or
make any settings.
Four multicolour LEDs indicate the operating status, charge state
and any faults that may occur (see “Faults and remedies”).
LED displays
Battery charge
state LED 1 and LED 3
displays
(solar module
not charging) LED 1 and LED 3 dis-
plays
(solar module
charging)
100 %
Green flashing
1)
Green slowly alternating
between bright/dark
Green fully lit
2)
50 % Yellow fully lit
Yellow slowly alternating
between bright/dark
0 %
Red fully lit
3)
Red slowly alternating
between bright/dark
Red flashing
4)
1 )
Cut-off voltage reached, excess energy available
2 )
Charge state: fully charged
3 )
Charge state: low charge
4 )
Battery deeply discharged