Steca PA Link1, Инструкция по установке и эксплуатации

Страница: 9 / 15

756.409 | Z02 | 16.31 9
4.2 Connection
WARNING
Danger of explosion from sparking! Danger of electric shock!
X
The parallel switch box may only be connected to the local consumer devices
and the inverters by trained personnel and in accordance with the applicable
regulations.
X
Connections must always be made in the sequence described below.
X
The cables pre-fitted to the inverter may not be extended and must not be
damaged.
X
Only touch-proof voltages (according to SELV/DVC A or appropriate
guidelines) may be used at the RJ45 connections.
X
Use only the intended cables and connections.
4.2.1 Connecting the consumers
NOTE
The terminals and data connections are pictured in detail in the figure on
page 20.
X
Strip approx. 10 mm of both wire ends of the consumer cable.
X
Introduce the consumer cable through the right-hand strain relief.
X
Connect the consumer cable to a distribution board with a circuit breaker
according to the applicable regulations, at the L and N terminals of the
AC OUT consumer output. Tightening torque: 1.2 Nm to 1.5 Nm.
Or
X
Install alternating current socket at the terminals of the AC OUT consumer
output according to the country-specific regulations.
In the event that, due to local regulations or the AC consumers, grounding is
required:
X
Carry grounding out following the adjacent diagram (if TN net is permit-
ted).
X
Tighten the screw of the right-hand strain relief.
4.2.2 Connecting the Solarix PI master and slaves
ATTENTION
Risk of destruction of the device.
X
Never short-circuit the outputs of the stand-alone inverters Solarix PI or the PA
Link1.
X
Never connect other devices to the RJ45 connections (Master, Slave). Use the
connections exclusively for the PI communication.
X
Insert cable of the stand-alone inverter Solarix PI master from the right into
the bottom part of the second strain relief.
X
Depending on the number of slaves, insert the cables of further stand-
alone inverters Solarix PI into the bottom parts of the still free strain reliefs.
X
Place clamp clips of the strain reliefs onto the bottom parts and loosely
fasten each one with two screws.
ATTENTION
The stand-alone inverters may be damaged in case of incorrect connection.
X
Make sure that all blue cables are connected to N and all brown cables are
connected to L.
X
Strip approx. 8 mm of all wire ends.
X
Connect the wires in the parallel switch box in accordance with the termi-
nals’ labels (see chapter 3 “Description of the connections"). Tightening
torque: 0.5 Nm.
Blue: N
terminals
Brown: L terminals
EN