Stealth Cam STC-G45NGMAX, Инструкция по эксплуатации

Страница: 13 / 54

www.stealthcam.com Page
877-­‐269-­‐8490
13
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)

TIME LAPSE (TL) : In this mode the camera will take a designated amount of pictures with a designated time
out between the designated hours of operation even if there is no activity in front of the camera.
"
PHOTO RES –
8
.0 MP (default): This setting is used to determine the Megapixel resolution of each image taken
by the camera. With this option blinking, use the UP or DOWN arrow key to move between the options of:
2 6
MP,
16
MP,
8
MP or
4
MP. The higher the resolution of an image the more space the file will take on the SD
memory card.
"
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time that the camera will
wait before it reinitializes its PIR sensor for the next activation. With the TL mode this setting is only active if TL
Delay is set to 1 min or greater. This setting can be changed between the numbers of 00min 0
2
sec to 59min
59sec. With this option blinking, use of the UP and DOWN arrows will allow the minutes setting to be changed
from 00 to 59. Once this setting is on the appropriate minutes, press the RIGHT arrow key to move to the
seconds setting and it will start to blink. Use of the UP and Down arrows will allow the seconds setting to be
changed from 05 to 59 (0
2
to 59
seconds
if minutes = 00).
"
PIR RANGE – STANDARD (default): This setting allows you to control the sensitivity distance the PIR will be
activated. These distances can vary depending on environmental conditions. This setting will change
between EXTENDED which will trigger about 1/3 further than the STANDARD setting, the STANDARD
setting, or NEAR FIELD that will only trigger on movement closest to the camera.
"
REDUCE BLUR – ADVANCED (default): This setting is used to determine if the camera should use the MATRIX
Blur reduction technology to dramatically reduce the blur effect resulting in clearer night time infrared shots.
(STANDARD) Minimizes blurring effect in images while retaining long-range night image capability.
(ADVANCED) Enhanced blur reduction providing a balance between brightness and image sharpness.
(PROGRESSIVE) Maximum blur reduction achieved through faster shutter speed. This setting may cause a slight
reduction in night time range and increased grain in the image. With this option blinking, pressing the UP or
DOWN arrow buttons will cause the camera to cycle between the three options of STANDARD, ADVANCED, and
PROGRESSIVE.
"
IR BRIGHTNESS CONTROL – FULL (default): This setting is used to adjust the brightness of the IR LEDS. With this
option blinking, use the UP or DOWN arrow key to move between FULL and HALF brightness. On FULL brightness
the LEDs have a further flash range making it ideal for large open areas. HALF brightness is ideal for close up
shots preventing the subject from being overexposed.
"
SMART IR - O FF (default) : This setting is used to to toggle Smart IR ON and OFF. With this option blinking, use
the UP or DOWN arrow to move between ON and OFF. While enabled the camera will take color images during
the dusk and dawn lighting conditions.
While Smart IR is ON, Photo Burst is limited to (1) image per triggering.