StarTrac Elliptical Edge, Руководство по обслуживанию

Страница: 49 / 74

INC._
Stride Belt Replacement
8. Using 1/8-in. Allen wrench, remove the three Allen screws from the top capture plate, and
separate the capture plates from the stride belt. See Diagram U.
POINTS TOWARD FRONT
OF WELDED RAIL
Diag. U
9. Using 1/2-in. hex head socket wrench and 1/2-in, open-end wrench, remove the front
stride belt pulley (and bolt) from inside the skate rail. See Diagram V.
o
I
Diag. V
NOTE: installing
the stride belt in the
skate rail, the punched
holes in the belt face
up, the arrows point to
the rear of the skate
rail.
5.22
10. Pull the stride belt out through the back of the skate rail.
Install the stride belt:
1. Insert the stride belt into the skate rail (from the rear end) and route the stride belt through
the skate rail. MAKE SURE the belt is straight when installed in the skate rail. See Dia-
gramW.
Diag.W
2. Install the front stride belt pUlley in the stride belt. Using 1/2-in. hex head socket wrench
and 1/2-in. open end wrench, secure the front stride belt pulley to the skate rail with the
bolt. TIGHTEN THE SOLT SECURELY. .
3. Install the rear stride belt pulley in the stride belt. Using 1/2-in. hex head socket wrench
and 1/2-in. open end wrench, secure the read stride belt pUlley to the skate rail with the
bolt. TIGHTEN THE SOLT SECURELY.
4. Slide the shuttle forward on the skate rail until the shuttle rests against the front stride belt
pulley.
5. Using needle nose pliers, CAREFULLY pull the section of the stride belt with the three
Elliptical .Edge Service Manual