StarTrac Elliptical Edge, Руководство по обслуживанию

Страница: 13 / 74

Tools Required:
Phillips head screwdriver
9/16-in. open-end wrench
Belt tensioner gauge
Remove the front shroud:
1. Using Phillips head screwdriver, remove the eight Phillips head screws from the front shroud.
2. Lift the front shroud off the unit.
Check the crank belt tension:
1. Using belt tensioner gauge, check that crank belt tension is 80 pounds.
2. If a belt tensioner gauge is not available, check the crank belt tension by pressing down hard on top of the belt,
midway between the transmission idler pulley and the crank pulley. The belt should deflect between 3/8-in.-1/2-
in. (9.5-12.5 mm).
3. If crank belt tension is less than 80 pounds, the crank belt must be adjusted.
Re-tension the crank belt:
1. Using 9/16-in. open-end wrench, loosen the transmission idler tension nut to allow adjustment of the transmis-
sion idler tension bolt.
1. Using 9/16-in. open-end wrench, tighten the transmission idler tension bolt to increase crank belt tension.
2. Using belt tensioner gauge to check crank belt tension, continue to tighten the transmission idler tension bolt to
achieve 80 pounds tension.
• If a belt tensioner gauge is not available, check the crank belt tension by pressing down hard on top of the
belt, midway between the transmission idler pulley and the crank pulley. The belt should deflect between
3/8-in.-1/2-in. (9.5-12.5 mm).
3. Once the correct crank belt tension is obtained, tighten the transmission idler tension nut SECURELY using
9/16-in. open-end wrench.
Install the front shroud:
1. Install the front shroud in position on the unit.
2. Using Phillips head screwdriver, secure the front shroud to the unit with the eight Phillips head screws.
Elliptical Edge Service Manual
2.5