StarTrac Elliptical Edge, Руководство по обслуживанию

Страница: 48 / 74

Stride Belt Replacement,·
•
3. Using 7/16-in. hex head socket wrench and 3/16- in. Allen wrench, remove the top two
bolts from the belt guide bracket. Once the bolts are removed, CAREFULLY dislodge the
stride belt from the groove in the guide bracket. See
S•
-----
FRONT VIEW
Diag. S
4. Using 1/2-in. hex head socket wrench and 1/2-in. open-end wrench, remove the rear
stride belt pulley (and bolt) from inside the skate rail. See
Diagram T.
----
-
/
/
Diag. T
5. Using 3/16-in. hex head socket wrench, remove the four screws (from underneath the
shuttle) securing the footpad to the shuttle. Remove the footpad.
6. Using 3/16-in. hex head socket wrench, remove the four screws (at the rear of the shut-
tle) securing the shuttle to the capture plates.
7. Using needle nose pliers, CAREFULLY pull the section of the stride belt containing
capture plates out the access hole in the side of the skate rail.
Elliptical Edge Service Manual
5.21