Instruction Manual
100
Enabled
Controls whether the policer is enabled on this switch port.
Rate
Controls the rate for the policer. The default value is 500. This
value is restricted to 100-1000000 when the “Unit” is “kbps” or
“fps”, and it is restricted to 1-3300 when the “Unit” is “Mbps”
or “kfps”.
Unit
Controls the unit of measure for the policer rate as kbps,
Mbps, fps or kfps . The default value is “kbps”.
Flow Control
If flow control is enabled and the port is in flow control mode,
then pause frames are sent instead of discarding frames.
1. On the main screen of the Web management UI, click
Configuration
>
QoS
>
Port
Policing
.
2. Evoke which port needs to enable the QoS Ingress Port Policers and type the Rate
limit condition.
3. Scroll down to select the Rate unit.
4. To save your settings, click
Save
.
To restore the previous settings, click
Reset
.
Change the Port Scheduler settings
Use the QoS Egress Port Schedulers to show an overview of the Egress Port Scheduling
Table, including queue mode and weight. Click Port number to configure.
You can access the screen by clicking
Configuration
>
QoS
>
Port Scheduler
.
Menu option
Description
Port
The logical port for the settings contained in the same row.
Click on the port number in order to configure the schedulers.
Mode
Shows the scheduling mode for this port.
Qn
Shows the weight for this queue and port.
1. On the main screen of the Web management UI, click
Configuration
>
QoS
>
Port
Scheduler
.
2. On the
Overview
screen, click
port number into Scheduler
setting for a specific
port.
3. To save your settings, click
Save
.
To restore the previous settings, click
Reset
.
