Stark 65064, Инструкция по эксплуатации и правила безопасности

Страница: 7 / 22

CONTROL FUNCTIONS
6
OIL WARNING LIGHT:
When the oil level falls below recommended levels, the oil warning light
lights up and the engine will automatically stop. Refill with oil to get the engine to start again. If
the engine stalls or doesn’t start, turn the engine switch to “ ON ” and pull the recoil starter. If the oil
indicator light flickers, the engine oil is insufficient, add oil and restart.
OVERLOAD INDICATOR LIGHT:
The overload indicator light comes on when an overload of
a connected device is detected, the inverter control unit overheats or the AC output voltage rises.
Then the AC protector will trip, stopping the power generation in order to protect the generator and
any connected electrical devices. The AC pilot light will go off and the overload indicator light will
stay on, but the engine will stop running. When the overload indicator light comes on and power
generation stops, proceed as follows:
1. Turn off any connected electric devices and stop the engine.
2. Reduce the total wattage of connected appliances into the rated output.
3. Check for blockages in the cooling air inlet and around the control unit. If any blockages are
found, remove them.
4. After checking, restart the engine.
TIP:
The overload indicator light may come on for a few seconds at first
when using electric devices that require a large starting current, such a
compressor or submergible pump. However, this is not a malfunction.
AC PILOT LIGHT (GREEN): The AC pilot light comes on when the
engine starts and produces power.
DC PROTECTOR: The DC protector turns to OFF automatically when
the electric device being connected to the generator is operating and the
current is above the rated flows. To turn on DC proctor by pressing the
ON button. ON is direct current output, OFF signifies direct current is not
output.
CAUTION
Reduce the load of the connected electric device below the specific rated output of the generator if
the DC Protector turns off. If the DC Protector turns off again, stop using the device immediately and
consult a qualified technician.
ECONOMY CONTROL SWITCH (ECS):
When the ECS switch is
turned on, the economy control unit controls the engine speed according
to the connected load. The results are better fuel consumption and less
noise. When the ECS is turned OFF, the engine runs at the rated speed
(4500r/min) regardless of whether is a load connected or not.
TIP:
The ECS must be turned to OFF when using electric devices that
require a large starting current, such as a compressor of a submergible
pump.