6
execution of this parameter, the modem handshakes.
&
Wait for credit card dialing tone before continuing with the dial string. If bong is not detected
within the time specified by S7, the modem will abort the rest of the sequence.
'
Dial pause: the modem will pause for a time specified by S8 before dialing the digits following
the ",'".
;
Return to command state: added to the end of a dial string, this causes the modem to return to
the command state after it processes the portion of the dial string preceding the ";".
^
Toggles calling tone enable/disable: applicable to current dial attempt only.
()
Ignored: may be used to format the dial string.
-
Ignored: may be used to format the dial string.
<i>
Invalid character: will be ignored.
En - Command Echo
The modem enables or disables the echo of characters to the DTE according to the parameter supplied.
E0
Disables command echo.
E1
Enables command echo. (Default)
Fn - Select Line Modulation (1442 ONLY)
This command selects the line modulation according to the parameter supplied. The line modulation is fixed
unless Automode is selected.
F0
Selects auto-detect mode. All connect speeds supported by the modem are possible
according to the remote modem's preference.
F1
Selects V.21 or Bell 103 according to the B setting as the only acceptable line speed resulting
in a subsequent connection.
F2
Not supported.
F3
Selects V.23 as the only acceptable line modulation for a subsequent connection. Originator
is at 75 bps and answerer is at 1200bps.
F4
Selects V.22 1200 or Bell 212A according to the B command setting as the only acceptable
line speed for a subsequent connection.
F5
Selects V.22 bis as the only acceptable line modulation for a subsequent connection.
F6
Select V.32bis 4800 or V.32 4800 as the only acceptable line modulation for a subsequent
connection.
F7
Selects V.32 bis 7200 as the only acceptable line modulation for a subsequent connection.
F8
Selects V.32bis 9600 or V.32 9600 as the only acceptable line modulations for a subsequent
connection.
F9
Selects V.32bis 12000 as the only acceptable line modulation for a subsequent connection.
F10
Selects V.32 bis 14400 as the only acceptable line modulation for a subsequent connection.
Hn - Disconnect (Hang-Up)
This command initiates a hang up sequence.
HO
The modem will release the line if the modem is currently on-line, and will terminate any test
that is in progress.
H1
If on-hook, the modem will go off-hook and enter command mode.
