Stanley SCH121, Руководство пользователя

Страница: 8 / 48

8
ENGLISH (
Original Instructions)
Regardless of whether a shipment is considered excepted
or fully regulated, it is the shipper’s responsibility to consult
the latest regulations for packaging, labeling/marking and
documentation requirements.
Transporting batteries can possibly cause fire if the battery
terminals inadvertently come in contact with conductive
materials. When transporting batteries, make sure that
the battery terminals are protected and well insulated from
materials that could contact them and cause a short circuit.
The information provided in this section of the manual is
provided in good faith and believed to be accurate at the
time the document was created. However, no warranty,
expressed or implied, is given. It is the buyer’s responsibility
to ensure that its activities comply with the applicable
regulations.
Battery pack
Battery type
The SC122 operates on a 12V Max as well as 10.8V battery
packs.
Storage recommendations
1. The best storage place is one that is cool and dry
away from direct sunlight and excess heat or cold. For
optimum battery performance and life, store battery
packs at room temperature when not in use.
2. For long storage, it is recommended to store a fully
charged battery pack in a cool, dry place out of the
charger for optimal results.
NOTE : Battery packs should not be stored completely
depleted of charge. The battery pack will need to be
recharged before use.
Labels on charger and battery pack
In addition to the pictographs used in this manual, the labels
on the charger and the battery pack may show the following
pictographs:
Read instruction manual before use.
See Technical Data for charging time.
Battery charging.
Battery charged.
Battery defective.
Hot/cold pack delay.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care for the
environment.
Charge STANLEY battery packs only with
designated STANLEY chargers. Charging battery
packs other than the designated STANLEY
batteries with a STANLEY charger may make
them burst or lead to other dangerous situations.
Do not incinerate the battery pack.
WARNING : Prior to assembly and adjustment,
always remove the battery pack. Always switch
off the tool before inserting or removing the
battery pack.
WARNING : Use only STANLEY battery packs
and chargers.
Inserting and removing the battery pack from the tool
(Fig C)
WARNING : To reduce the risk of serious personal
injury, place the forward/reverse button in the
lock-off position or turn tool off and disconnect
battery pack before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
NOTE : Make sure your battery pack (7) is fully charged.
To install the battery pack into the tool handle
1. Align the battery pack with the rails inside the handle.
2. Slide it firmly into place until you hear the lock snap into
place.
To remove the battery pack from the tool
1. Press the release button (5) and firmly pull the battery
pack out of the tool handle.
2. Insert battery pack into the charger as described in the
charger section of this manual.
USE
Proper hand position (Fig A, H)
WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position as
shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction. Proper hand position requires
one hand on the main handle (9).