Stanley SCD2, Руководство пользователя

Страница: 11 / 72

11
ENGLISH
f
Use reverse (button pushed to the right) for removing
fasteners.
Note: When moving from forward to reverse, or vice versa,
always release the trigger switch first.
Drilling
f
Use sharp drill bits only.
f
Support and secure work properly, as instructed in the
Safety Instructions.
f
Use appropriate and required safety equipment, as
instructed in the SafetyInstructions.
f
Secure and maintain work area, as instructed in the
SafetyInstructions.
f
Run the drill very slowly, using light pressure, until the
hole is started enough to keep the drill bit from slipping out
of it.
f
Apply pressure in a straight line with the bit. Use
enough pressure to keep the bit biting but not so much as to
stall the motor or deflect the bit.
f
Hold the drill firmly with two hands, one hand on
the handle, and the other gripping the bottom around the
battery area or the auxillary handle if provided.
f
Do not click the trigger of a stalled drill off and on
in anattempt to start it. Damage to the drill can
result.
f
Minimize stalling on break through by reducing ressure
and slowly drilling through the last part of the hole.
f
Keep the motor running while pulling the bit out of a
drilled hole. This will help reduce jamming.
f
Make sure switch turns drill on and off.
Drilling in wood
Holes in wood can be made with the same twist drill bits
used for metal or with spade bits. These bits should be
sharp and should be pulled out frequently when drilling to
clear chips from the flutes.
Drilling in metal
Use a cutting lubricant when drilling metals. The exceptions
are cast iron and brass which should be drilled dry. The
cutting lubricants that work best are sulfurized cutting oil or
lard oil.
LED work light
When drill is activated by pulling the trigger switch (1), the
integrated LED work light (8) will automatically illuminate
the work area.
Note: The work light is for lighting the immediate work
surface and is not intended to be used as a flashlight.
Bit tip storage
A bit storage slot (9) is built into the base of the tool.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never
let any liquid get inside the tool; never immerse any part of
the tool into a liquid.
@
Important! To ensure product SAFETY and
RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this
manual) should be performed by authorized
service centers or other qualified organiza-
tions, always using identical replacement
parts. Unit contains no user service able
parts inside.
ACCESSORIES
@
Warning! Since accessories, other than
those offered by STANLEY have not been
tested with this product, use of such acces-
sories with this tool could be hazardous.
To reduce the risk of injury, only STANLEY
recommended accessories should be used
with this product.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not
be disposed of with normal household
waste.
Should you find one day that your
STANLEY product needs replacement,
or if it is of no further use to you, do
not dispose of it with household waste.
Make this product available for separate
collection.