Stanley SCD2, Руководство пользователя

Страница: 10 / 72

10
ENGLISH
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release button (f) and firmly pull the battery
pack out of the tool handle.
2. Insert battery pack into the charger as described in the
charger section of this manual.
OPERATING INSTRUCTIONS
Safety warnings and instructions: Drills
@
WARNING! Before using tool, read all
instructions and cautionary markings on tool.
@
WARNING! Drill may stall (if overloaded or
improperly used) causing a twist. Always
expect the stall. Grip the drill firmly with
two hands to control the twisting action and
prevent loss of control which could cause
personal injury. If a stall does occur, release
the trigger immediately and determine the
reason for the stall before re-starting.
Trigger switch & forward/reverse button (Fig. D)
f
The drill is turned ON and OFF by pulling and
releasing the trigger switch (1) shown in Fig. D. The
farther the trigger is depressed, the higher the speed
of the drill.
f
A forward/reverse control button (2) determines the
rotational direction of the tool and also serves as a lock off
button.
f
To select forward rotation, release the trigger switch
and depress the forward/reverse control button on the right
side of the tool.
f
To select reverse, depress the forward/reverse control
button on the left side of the tool.
f
The center position of the control button locks the
tool in the off position. When changing the position of the
control button, be sure the trigger is released.
Adjusting torque control (Fig. E)
This tool is fitted with a torque adjustment collar (3)
to select the operating mode and to set the torque for
tightening screws. Large screws and hard workpiece
materials require a higher torque setting than small screws
and soft workpiece materials.
f
For drilling in wood, metal and plastics, set the collar to
the drilling position symbol .
f
For screwdriving, set the collar to the desired setting.
If you do not yet know the appropriate setting, proceed as
follows:
f
Set the collar to the lowest torque setting.
f
Tighten the first screw.
f
If the clutch ratchets before the desired result is
achieved, increase the collar setting and continue tightening
the screw. Repeat until you reach the correct setting. Use this
setting for the remaining screws.
Dual range switch (Fig. F)
The dual range feature of your drill allows you to shift gears
for greater versatility.
f
To select low speed, high torque setting (position 1), turn
tool off and permit to stop. Slide gear shifter button (4) away
from the chuck.
f
To select the high speed, low torque setting (position 2),
turn tool off and permit to stop. Slide gear shifter button back
toward the chuck.
Note: Do not change gears when tool is running. If you are
having trouble changing gears, make sure that the dual
range gear button is either completely pushed forward or
completely pushed back.
Keyless chuck (Fig. G)
Warning! Make certain the battery pack is removed
to prevent tool actuation before installing or removing
accessories.
To insert a drill bit or other accessory:
1. Grasp the chuck (5) and rotate it in the counterclockwise
direction, as viewed from the chuck end.
2. Insert the bit or other accessory fully into the chuck,
and tighten securely by rotating the chuck in the clockwise
direction as viewed from the chuck end.
@
Warning! Do not attempt to tighten or loosen
drill bits (or any other accessory) by gripping
the front part of the chuck and turning the
tool on. Damage to the chuck and personal
injury may occur when changing acces-
sories.
Screw driving
f
For driving fasteners, the forward/reverse button should
be pushed to the left.