Stanley QPM CORDLESS TOOL, Инструкция по эксплуатации

Страница: 32 / 56

Cordless Tool
26
Installing and Removing the Battery Pack
hand or against your body is unstable and may lead to loss of control.
CAUTION
• When not in use, place tool on its side on a stable surface where it will not cause a tripping or falling hazard.
Some tools with large battery packs will stand upright on the battery pack but may be easily knocked over.
The label on your tool may include the following symbols. The symbols and their definitions are as follows:
V Volts Ah Amp hours
Nm Newton meter RPM Revolutions per minute
Wh Watt hours Safety alert symbol
2.3.1.1 Accessories
Since accessories, other than those offered by STANLEY, have not been tested with this product, use of such
accessories with this tool could be hazardous. To reduce the risk of injury, only STANLEY recommended accessories
should be used with this product.
Recommended accessories for use with your tool are available from your local service center.
2.4 Installing and Removing the Battery Pack
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack into the tool handle, align the battery pack with the rails inside the tool’s handle and
slide it into the handle until the battery pack is firmly seated in the tool and ensure that it does not disengage.
Installing the battery pack into the tool does not turn the tool on. After the battery pack is inserted in the tool,
press the start trigger switch to turn the tool on. After the tool turns on it will connect wirelessly to the associated
QPM Expert Alpha controller if it is setup to do so.
One of the two blue READY lights will illuminate when the tool is ready to run.
!