Stanley QPM CORDLESS TOOL, Инструкция по эксплуатации

Страница: 13 / 56

Instruction Manual
7
Introduction
1.5.2 Safety Instructions for Cordless Tools and Controllers
WARNING
To Avoid Injury:
• Save these instructions for future reference.
• Read and understand all the safety recommendations and all operating instructions before operating tools
and controllers. Failure to follow all instructions listed below may result in electric shock, fire and/or serious
personal injury.
• Train all operators in the safe and proper use of power tools. Operators should report any unsafe condition
to their supervisor.
• Follow all safety recommendations in the manual that apply to the tools, battery packs and chargers being
used and the nature of the work being performed.
• Verify that all warning labels illustrated in this manual are readable. Replacement labels are available at no
additional cost from STANLEY Assembly Technologies.
• Only allow suitably qualified personnel to install, program, or maintain this equipment and or system. Follow
all manufacturer installation instructions and applicable regulatory electrical codes and safety codes.
• These persons must be knowledgeable of any potential sources of danger and maintenance measures as set
out in the Installation, Operations, and Maintenance manual.
• This product must be transported, stored, and installed as intended, and maintained and operated with care
to ensure that the product functions correctly and safely.
• Persons responsible for system planning and design must be familiar with the safety concepts of automation
equipment.
• Install tools in dry, indoor, non-flammable, and non-explosive environments only–Humidity: 0 to 95% non-
condensing and Temperature: 32 to 122 ºF (0 to +50 ºC).
• Do not install worn, damaged, or modified equipment that may be unsuitable for safe use.
• Controller plugs must match the outlet and must be earth grounded. Never modify a plug in any way or use
any adaptor plugs.
• Avoid body contact with electrically energized surfaces when holding a grounded tool.
• Prior to connecting a power source, always ensure the tool or controller is turned off.
• Limit controller access to trained and qualified personnel. Lock controller cabinets.
• Only use equipment and accessories specifically designed to operate with Stanley assembly tools and use
them only in the manner for which they are intended.
• Store idle tools and accessories in a safe location accessible only by trained persons.
• Disconnect power source (battery pack, electricity, etc.) from tool or controller prior to making adjustments,
changing accessories, or storing.
• Prior to operation, always check and test tools and accessories for damage, misalignment, binding or any other
condition that may affect operation. Maintenance and repair should be performed by qualified personnel.
• Do not operate tools in or near explosive environments or in the presence of flammable liquids, gases, dust,
rain or other wet conditions.
• Keep the work area clean, well lit and uncluttered.
• Keep unauthorized personnel out of the work area.