Stanley QPM CORDLESS TOOL, Инструкция по эксплуатации

Страница: 43 / 56

Instruction Manual
37
Tool Operation
memory every 100 cycles or every hour. If the tool is de-energized before the cycle counts are written the number
buffered since last write will be lost.
Odometer Counter Records the total number of fastening cycle the tool has completed during its
lifetime.
Trip Counter Records the number of fastening cycles the tool completed since the last reset to
zero.
PM Counter
Records the number of fastening cycles the tool completed since the last reset to
zero. Interacts with PM Threshold.
PM Threshold A static value set by the end user. When the PM Counter exceeds the PM Threshold
(Limit), the controller provides a maintenance alert. The alert is an orange indicator
on the front of the controller and on the tool.
The controller reads the fastening cycle counters from the tool on each power up.
3.4.2 Fastening Cycle Data
The QPM cordless tool stores data for 500 fastening cycles and 1 trace. These values can be viewed and retrieved
using the QPM Expert Alpha controller. This data can be analyzed to determine root cause of failures when
securing the fastener. Please contact your STANLEY Sales Engineer for information or assistance on STANLEY
training and data analysis.
This data can be retrieved manually or automatically. If an enterprise level client/server data collection software
system is employed all the data from all the tools in the facility can be collected into one database and displayed
using the end users graphic reports software. The QPM cordless tool will need to remain in radio contact with an
assigned QPM Expert controller to facilitate data collection.
3.5 Worklights
There are two worklights located above the MFB, below the motor. The worklights are activated when the trigger
switch is depressed, and will automatically turn off after the programmed amount of seconds after the trigger
switch is released. If the trigger switch remains depressed, the worklights will remain on.
NOTE : The worklights are for lighting the immediate work surface and are not intended to be used as a flashlight.
3.6 Tool Operation
Pair the tool to a QPM Expert controller. See
“2.5 Pairing Tool to Controller” on page 27
. Read the
QPM Expert controller to understand programming of strategies to run the QPM cordless tool.
3.6.1 Program Selection
The QPM cordless tool can have up to 16 Tasks programmed. Those Tasks are divided amongst up to 16 Jobs. The
MFB can be used to select Job/Task 1 and 2. If it is desired to select and run more than two programmed Jobs or
Tasks the QPM cordless tool will need to remain in radio contact with an assigned QPM Expert Alpha controller.
The QPM Expert Alpha controller has various means of changing the selected Job/Task such as inputs or barcode
scans of product. Read the QPM Expert Alpha controller manual to understand how to select a Job/Task.
3.6.2 Directional Control
!