Stanley ARGON F650, Инструкция по установке, обслуживанию и эксплуатации

Страница: 20 / 64

Installation & Operating Manual for Argon F650 & F900 – Balanced Flue Gas Stoves
20
Natural Gas & LPG Models
2.5 Pairing The Remote
The remote that comes with your stove should already be paired to your burner. However, if it becomes
un-paired or you have had a replacement remote, follow the steps below to re-pair your remote.
To pair the Remote Control to your burner follow the below steps.
STEP 1 -
Turn on Remote Control
–
(fitted with 2 x AAA Duracell batteries)
GENTLY Hold in Reset button (Fig. 2) on the side of the black controller box (Receiver Unit) under the
burner unit (Fig.2 using a pen or pin until it beeps twice. Then Release the Reset button.
Fig 1 - Controller Box
Please check all wires
are fitted and not loose.
Controller box located
under the burner unit.
Fig 2 - Reset Button
GENTLY Push in with
ball point pen or
similar.
STEP 2
- Press and hold the Down arrow button on the handset remote until you hear a single beep.
Release Down arrow button.
STEP 3 -
Turn off Remote control.
STEP 4 -
Turn the Remote control back on, after approximately ten seconds the burner on the stove will
start ignition. Once this happens you know your remote is successfully paired.
IMPORTANT – ONLY USE Duracell Alkaline Batteries, DO NOT FIT ANYTHING ELSE.
DO NOT use rechargeable batteries. The stove comes with Duracell Industrial Alkaline batteries
fitted. If using a rear battery pack DO NOT put batteries in the Control Box (Receiver Unit) this
will damage the controller and void the warranty
STEP 2
Hold Down this
Arrow Button
Read Instructions
Above
STEP 3 & 4
Turn OFF/ON
Read Instructions
Below