Stanley 71504, Инструкция по эксплуатации и обслуживанию

Страница: 5 / 44

1.8 ADDITIONAL SAFETY INSTRUCTIONS FOR HYDRAULIC POWER TOOLS
• The operating hydraulic supply must not exceed 400 bar (5800 PSI).
• Oil under pressure can cause severe injury.
• Do not fi t fl exible hydraulic hoses rated at less than 700 bar (10,000 PSI) working pressure at a fl ow rate of 2.73 l/min
(200 in
3 /min).
• Disconnect hydraulic hoses from the pump unit when tool is not in use, before changing accessories or when making
repairs.
• Whipping hoses can cause severe injury. Always check for damaged or loose hoses and fi ttings.
• Prior to use, inspect hydraulic hoses for damage, all hydraulic connections must be clean, fully engaged and tight
before operation. Do not drop heavy objects on hoses. A sharp impact may cause internal damage and lead to
premature hose failure.
• Whenever universal twist couplings (claw couplings) are used, lock pins shall be installed and whipcheck safety cables
shall be used to safeguard against possible hose-to-tool or hose-to-hose connection failure.
• DO NOT lift the placing module by the hose. Always use the placing module body.
• Keep dirt and foreign matter out of the hydraulic system of the tool as this will cause the tool to malfunction.
• Use only clean oil and fi lling equipment.
• Only recommended hydraulic fl uids may be used.
• Maximum temperature of the hydraulic fl uid at the inlet is 110°C (230°F).
STANLEY Engineered Fastening policy is one of continuous product development and improvement and we reserve
the right to change the specifi cation of any product without prior notice.
5
O R I G I N A L I N S T R U C T I O N E N G L I S H