61
5.12.4
Tokens
This discount uses acceptance of the IDX tokens to either give a discount towards a wash or credit
towards a wash.
There are five steps required to setup the token discounts:
·
train
the coin acceptor to recognize the tokens to be accepted
·
identify the
number
of different tokens (different token designs) to be used
·
name
each token
·
determine
if it will be used as a credit or a discount towards a wash package(s)
·
programming the GXP to recognize the token
The maximum number of tokens that can be used is four.
Step 1
– Program the IDX coin acceptor to accept the token(s). The following procedure is used to
accomplish this. You will need 6 samples of each different token to be used. If you are using multiple
tokens, all of them will be trained during this procedure. The coin acceptor can distinguish between 4
different token designs so up to 4 different token types can be used. When the acceptor has been
trained for each different token type, proceed to the next step.
·
Remove the coin acceptor assembly from the machine. The coin acceptor is held in by either four
#6-32 nuts or two #10-32 nuts.
·
With the acceptor plugged in, slide the front cover up using your thumb as shown below and
identify the three controls to be used in this procedure; rotary dial, push button and LED.
·
Set the “rotary switch position” for the first token. The first token will be rotary switch position 3.
Position 3 is reserved for the generic label “Token 1”. Note – you will use position 4 for “Token
2”, position 5 for “Token 3” and position 6 for “Token 4” in future steps.
Coin programming
note
: if you are training the acceptor to take quarter coins then use rotary switch position 1, use
switch position 2 for $1 coins.
·
Press the black button once for Token 1, twice for Token 2, 3 times for token 3 and 4 times for
token 4.
Coin programming note
: Press the black button once for Quarters and four times for $1
coins.
·
Very Important - Slide the cover back on the unit each time you are training a new coin to make
sure outside light (sun light) does not interfere with the optical coin sensors.
LED
Rotary Switch
Push
