Standard Change-Makers BCX Series, Инструкция по установке и эксплуатации

Страница: 23 / 92

21
3. Noise Potential Check
When placed across the NEUTRAL and GROUND terminals, a volt-ohmmeter should indicate
no more than .5 volts AC. Readings greater than .5 volts AC indicate a poor grounding condition
that could result in noise problems for the electronic circuitry.
If you are hard wiring the changer the same checks should be performed on the supply line going to the
changer. Any deviation from these requirements may result in unreliable performance from your machine.
3.0 LOCK OPERATION
T-handle Lock Operation
The T-handle lock that the Modular Machine Series is equipped with provides quick and easy access to
the interior of the changer with maximum security. To disengage the lock it is only necessary to unlock
the mechanism and turn the handle counter clockwise until it disengages from the interior lock mechanism
(approximately five turns), then pull the door open. The lock handle must be parallel to the floor for the
lock to disengage on MC100, MC200, MC400RL, MC700 and MC900 cabinets; the lock must be
perpendicular to the floor on the MC300RL and MC500RL-DA cabinet. To lock the door, turn the handle
parallel to the floor then push the door closed. The lock will be automatically engaged as the door is
closed. If the door is pushed all the way closed, it will only be necessary to turn the handle a couple of
turns until the lock tightens. The lock handle can then be pushed into the recess of the door, securely
locking the cabinet. See photos below of lock t-handle and plug locks.
WARNING!
Do not place cabinet lock keys inside the changer as they may be inadvertently locked inside.
SUGGESTION: Place the extra key and key number tag to the changer in a safe place in the event it is
needed at a later date.
Lock T-Handle
Without Plug Lock
Top – Medeco Plug Lock w/keys (Optional)
Bottom – Ace Plug Lock w/keys (Standard)