Standard Change-Makers BCX Series, Инструкция по установке и эксплуатации

Страница: 22 / 92

20
Remove all packing materials and shipping straps from the cabinet. Some items have yellow tags with
removal instructions.
After installation, replace coin dispenser(s) or, if they were shipped separately, remove them from their
cartons and install them. Plug in all electrical connectors.
2.7 Electrical Hook-Up
The changer need only be connected to a properly grounded electrical outlet (3
rd
wire ground back to main
service panel). We also recommend that the changer be wired on a dedicated line. A dedicated line is a
circuit which has no other equipment connected on the same circuit breaker or fuse. The purpose of a
dedicated line is to reduce the possibility of line interference, which may cause the changer to malfunction.
Some models have several cut outs allowing alternate wiring inlets. If the machine is located in a harsh
electrical environment, or if dedicated line is not feasible, the use of a high quality surge suppressor (same
as used for home computers) is recommended.
IMPORTANT
This machine must be grounded through a properly installed 3
rd
wire ground, which
extends intact to the main service panel.
2.8 The Locations Electrical Supply
If this machine has a service cord that ends in a 3-pin connector. The wall receptacle you plug the machine
into must be properly polarized and grounded. Operating your machine from an improperly connected
power source will VOID THE WARRANTY. The wall receptacle must be able to supply a constant 120
volts at 60Hertz. The receptacle should be protected by a 15 amp circuit breaker or fuse. The machine
should have its own electrical circuit. Perform checks on the power source as follows: (See photo to the
right)
1. Voltage Check
When placed across the HOT and NEUTRAL terminals, a volt-ohmmeter should indicate 110-
130 volts AC.
2. Polarity Check
When placed across the HOT and GROUND terminals, a volt-ohmmeter should indicate 110-130
volts AC.
HOT
NEUTRAL
GROUND