Staco Energy Unistar VP, Руководство пользователя

Страница: 8 / 42

Page | 1
1. Safety Warnings and EMC instructions
1.1 UPS Location
• Install your UPS indoors, away from excess moisture or heat, direct sunlight, dust and conductive
contaminants.
• Install your UPS in a structurally sound area. Your UPS is extremely heavy; take care when
moving and lifting the unit.
• Only operate your UPS at indoor temperatures between 32°F and 104°F (between 0°C and
40°C).
• Leave adequate space around all sides of the UPS for proper ventilation.
• Do not install the UPS near magnetic storage media, as this may result in data corruption.
• Do not mount unit with its front or rear panel facing down (at any angle). Mounting in this manner
will seriously inhibit the unit's internal cooling, eventually causing product damage not covered
under warranty.
1.2 Connections
• There is feedback protection inside.
• This UPS should be connected with properly grounded utility system ( TN grounding system).
• The input source for this unit must be single-phase rated in accordance with the equipment
nameplate and must be suitably grounded.
• Use of this equipment in life support applications where failure of this equipment can reasonably
be expected to cause the failure of the life support equipment or to significantly affect its safety or
effectiveness is not recommended.
• Do not use this equipment in the presence of a flammable anesthetic mixture with air, oxygen or
nitrous oxide.
• The UPS is connected to a DC energy source (battery). The output terminals may be live when
the UPS is not connected to an AC supply.
• An external branch circuit breaker at the UPS output side is strongly recommended to provide
overcurrent protection or easy disconnection of load device.
1.3 Maintenance
• Service and repair should be done only by trained personnel. During any service work to the
UPS, it should be turned off or manually bypassed. Note that potentially lethal voltages exist
within this unit as long as the battery supply is connected.
• Your UPS power module and battery module(s) do not require routine maintenance. Do not open
them for any reason. There are no user-serviceable parts inside.
• Before carrying out any kind of service and/or maintenance, disconnect the batteries and verify
that no current is present and no hazardous voltage exists at the terminals of high capacity
capacitor such as BUS-capacitors.
• Fuses should be replaced only with fuses of the same number and type and should be replaced
only by factory authorized personnel.
• The battery circuit is not isolated from the input voltage. Verify that no voltage between the
battery terminals and ground is present before maintenance or repair. Hazardous voltages may
occur between the battery terminals and the ground.