Spire 740-0788P, Инструкция по установке и руководство по эксплуатации и уходу

Страница: 12 / 61

Unpack and Place the Grill:
1. Remove all packaging materials and remove grill from the
shipping base.
2. Move grill close to desired outdoor location.
3. Open the grill hood.
4. Using utility knife to cut yellow straps and packing tape to
open box from top and remove the boxes.
5. Remove the warming shelf and grill grates from inside the
grill and remove the package inside the firebox.
6. Remove foam block and wrap from inside the grill.
7. Place the grill on the support base.
8. Place the Flame Tamer to the grill.
9. Place Cooking Grid and Warming Shelf as shown.
Install 20 lb Propane Tank Tray
The tank tray should be secured to a fixed location that can be
easily accessed and will allow the gas pressure regulator/ hose
assembly to connect to the 20 lb propane tank without kinking
or putting strain on the gas pressure regulator/ hose assembly.
1. Place the tank tray in a location that can be secured using
4 screws (supplied) through the predrilled holes.
2. Use 4 screws to secure the tank tray. The typical location
for a 20 lb propane tank is within the enclosure where the
tank can be turned on and off easily.
INSTALLATION INSTRUCTIONS
Unpack Grill
A. Four 5/32" x 10 mm truss head screws
12
Install Grill
Place grill into outdoor enclosure but leave enough room in the
back to connect to the gas supply.
LP Gas Installation
1. Check that the LP gas pressure regulator/hose assembly
is positioned under the grill (as shown in the following
illustration) and is not pinched or kinked.
2. Use 4 screws and the 2-piece 90
°
clamp mounting
bracket provided to attach the 90
°
brass connector to the
back of the enclosure. The brass connector is located
between the flexible gas hose and the LP gas
pressure/hose assembly.
A. 4 screws
B. 2 piece 90
°
clamp mounting bracket
A
B