Spire 740-0788P, Инструкция по установке и руководство по эксплуатации и уходу

Страница: 14 / 61

4. Remove any debris and inspect the valve connections,
port, and gas pressure regulator/hose assembly for
damage.
NOTE: Always keep the tank at 90
°
(upright) orientation
to provide vapor withdrawal.
5. Using your hand, turn the gas pressure regulator/hose
assembly anticlockwise to connect to the 20 lb propane
tank as shown.
Hand tighten only. Use of a wrench could damage the
quick coupling nut.
6. Open the tank valve fully by turning the valve
counterclockwise. Wait a few minutes for gas to move
through the gas line.
7. Before lighting the grill, test all connections by brushing on
an approved noncorrosive leak-detection solution. Bubbles
will show a leak.
8. If a leak is found, turn the tank valve off and do not use the
grill. Contact a qualified gas technician to make repairs.
9. The igniter battery is not factory installed. A “AA” size
alkaline battery is in the accessory box on the grill grate.
Install battery following the instructions in “Replacing the
Igniter Battery” section.
10. Go to “Check and Adjust the Burners” section.
To Disconnect the 20 lb Propane Tank:
1. Check that the burner control knobs are in the “OFF”
position and the grill is cool.
2. Check that the 20 lb propane tank is in the “OFF” position.
If not, turn the valve clockwise until it stops.
3. Using your hand, turn the gas pressure regulator/hose
assembly clockwise to disconnect to the 20 lb propane
tank as shown.
Hand loosen only. Use of a wrench could damage the
quick coupling nut.
4. Place dust cap on cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cap on
the valve outlet that is provided with the cylinder valve.
Other types of caps or plugs may result in leakage of
propane.
NOTE: If grill is to be converted to Natural gas, follow
instructions in the “Gas Conversions” section.
20 lb Propane Tank
IMPORTANT: : A 20 lb propane tank must be purchased
separately.
IMPORTANT: The gas pressure regulator/hose assembly
supplied with the grill must be used. Replacement gas pressure
regulator/hose assembly specific to your model is available
from your outdoor grill dealer.
To Install the 20 lb Propane Tank:
1. Install the 20 lb propane tank into the compartment below
the grill.
2. Tighten the locking screw against the bottom collar of the
20 lb propane tank to secure.
To Connect the 20 lb Propane Tank:
1. Check that the 20 lb propane tank is in the “Off” position. If
not, turn the valve clockwise until it stops.
2. Check that the 20 lb propane tank valve has the proper
type-1 external male thread connections per ANSI Z21.81.
3. Check that the burner control knobs are in the “Off”
position.
A. Gas pressure regulator/hose assembly
B. 20 lb propane tank
Gas Connection
14