© 2021 Mad Dogg Athletics, Inc. All rights reserved.
18
9
STEP8A:
INSTALL THE TABLET MOUNT
Locate the 2 bar washers and 4 bolts with
associated washers as shown and align the
holes with the threaded bosses underneath the
center section. Use the allen wrench to tighten
the allen bolts securely.
STEP8B:
ATTACH THE TABLET CLAMP
TO THE ARM
Push in and slide down gently to fully engage
the snap locks as shown. Note the orientation
of the tabs and slots.
Pivot bolts can be tightened for a stiffer angle
adjustment and should always be snug.
Use caution and
do
not over-tighten these bolts
.
STEP 8C:
ATTACH THE TABLET
Open holder tabs using two hands and place
tablet securely. Use caution to keep tablet side
controls away from holder tabs.
STEP 9:
INSTALL THE HANDLEBARS
The handlebars are installed in the same
fashion as the seatpost. Unscrew, pull out
and hold the handlebar pop-pin. Slide the
handlebar post all the way into the handlebar
tube. Release the handlebar pop-pin and
adjust the handlebars to make sure that the
pop-pin is engaged. Tighten the handlebar
pop-pin securely before riding.
8B
8C
8A
STEP 7:
INSTALL THE CRANK
Locate the left side crank and push it onto the
axle in the opposite orientation of the drive side
crank. Give the crank a tap with the hand at that
axle bolt location to make the connection snug.
Now find the 14mm crank bolt on the assembly
card and hand thread the bolt into the axle hole
as far as possible, making sure that the threads
are engaged and the bolt is straight. Use the
supplied 14mm socket wrench to tighten the bolt
clockwise. Make sure it is tight and then snap
the dust cap into the bolt hole.
7
