28 |
S p e d o 2 6 0 0 O p e r a t o r M a n u a l
S p e d o U K L t d
28
Spedo 2600 Pinless Cutter Operator Manual
Preliminary Manual Cut Operation
Press the START pushbutton. Check that the RED STOP pushbutton has
extinguished.
Press the In-Feed pushbutton and check that the leading edge of the paper
web advances to the guillotine blade.
Press the Manual Cross-Cut pushbutton and check that the guillotine blade
cuts across the full width of the paper web.
Press the START pushbutton a few times to produce some cut forms and
check the forms for correct cut position and depth. Fine tune the cut
position using the JOG pushbuttons.
It may also be necessary to re-adjust the side trimmers and the centre cutter
positions at this time.
Set the stacking guides and paper stops according to the position and size of
the cut forms.
Start Continuous Operation.
Start Continuous Operation
Once satisfied that the machine is operating correctly in manual operation,
select Continuous mode by pressing the self-locking Continuous pushbutton
and press START. The machine will now cycle at the values previously set.
This applies to cut and no-cut operation.
Stop Continuous Operation
Press the STOP pushbutton or release the Continuous pushbutton to
interrupt continuous operation. The machine will, however, continue its
current cycle and then stop. This applies to cut and no-cut operation.
Emergency Stop Operation
Open the protective cover. The machine will stop immediately in mid-cycle.
To start again, close the cover and resume the normal operating procedure
from the beginning.
Note that this method of stopping the machine is bad practice and should
not be used for normal operation. This applies to cut and no-cut operation.
Paper Run-out
The machine will continue to cycle until the trailing edge of the paper web
passes over the paper run-out switch. When this happens, the machine will
stop, leaving the last forms unprocessed. This applies to cut and no-cut
operation.
In this instance, de-select the Continuous pushbutton and cycle the
remaining forms through manually, by pressing the START pushbutton, using
the In-Feed pushbutton to advance the paper and the Manual Blade
pushbutton to cut the remaining forms.
