Speco H16HRLN, Руководство пользователя

Страница: 61 / 102

Alarm Management
DVR User Manual
55
9 Alarm Management
9.1 Sensor Alarm
To complete sensor alarm settings, you should enable the sensor alarm of each camera and then set up the alarm handling of each camera.
①
Click Start  Settings  Alarm  Sensor Alarm to go to the following interface.
②
Select schedule and the alarm type (NO or NC) according to trigger type of the sensor.
③
Enable the sensor alarm of each camera.
④
Check the “Duration”, “Record”, “Snapshot”, “Push”, “Alarm-out” and “Preset” and enable or disable the “Buzzer”, “Pop-up Video”, “Pop-up
Message Box” and “E-mail” as required.
⑤
Click “Apply” to save the settings.
The configuration steps of the above-mentioned alarm linkages are as follows:
Duration: The interval time between the adjacent motion detections. For instance, if the duration time is set to 10 seconds, once the system
detects a motion, it will go to alarm and would not detect any other motion (specific to camera) in 10 seconds. If there is another motion detected
during this period, it will be considered as continuous movement; otherwise it will be considered as a single motion.
Record : If selected, the “Trigger Record” window will pop up automatically (you can also click “Configure” button to pop up the window). Select
camera on the left side and then click to set a camera as the trigger camera. Select trigger camera on the right side and then click to
cancel the trigger camera. Click “OK” button to save the settings. The trigger cameras will record automatically when the sensor alarm is triggered.
Snapshot : If selected, the “Trigger Snapshot” window will pop up automatically. Configure the trigger camera in the window. The trigger cameras
will snap automatically when the sensor alarm is triggered.
Push: Choose ON or OFF. If it is ON, the system will send messages when the sensor alarm is triggered.
Alarm-out : If selected, the “Trigger Alarm-out” window will pop up automatically for configuration. The system will trigger the alarm-out
automatically when the sensor alarm is triggered. You need to set the delay time and the schedule of the alarm outputs. See 9.5.1 Alarm-out for
details.
Preset : If selected, the “Trigger Preset” window will pop up automatically for configuration. To add presets, please see 6.2 Preset Setting for details.
Buzzer : if enabled, the system will begin to buzz when the sensor alarm is triggered. To set the delay time of the buzzer, please see 9.5.4 Buzzer for
details.
Pop-up Video : After camera setup, the system will pop up the corresponding video automatically when the sensor alarm is triggered. To set the
duration time of the video, please see 9.5.3 Display for details.
Pop-up Message Box : if enabled, the system will pop up the corresponding alarm message box automatically when the sensor alarm is triggered.