Specialized KENEVO SL COMP CARBON, Руководство пользователя

Страница: 47 / 51

44
EN
FR
DU
CZ
SK
FREE
FREE
PL
„
Fig. 15.5: Open the charge port lid on the non-drive-side of the frame, near the bottom
bracket.
„
Fig. 15.6: Insert the RE plug into the charge port.
„
Fig. 15.7: Once the plug is seated correctly, twist the lever on the connector clockwise to
lock the cable in place.
„
To verify the RE is successfully connected to the system, check that the RE battery level is
indicated on the MasterMind TCU.
WARNING: When riding with a RE, always keep the RE cable plugged and locked
into the charge port of the bicycle. A loose cable can cause damage to your
bicycle and the RE and can become an obstruction which may cause you to lose
control and fall.
CAUTION: When installing the bottle cage, make sure to use the supplied
screws. Longer screw heads can cause damage to the RE.
WARNING: Always use the supplied battery retainer band when riding.
15.2. BATTERY DISCHARGE OPTIONS
„
When the RE is plugged in, the system default is to discharge both the RE and the internal
battery simultaneously.
„
Using the Mission Control App, you can adjust the default to completely discharge the
RE(s) first. This will require you to restart the bicycle to take effect.
„
When riding in “RE first” mode, once the RE reaches a low charge level, the power assistance
will be reduced, even if the internal battery is fully charged. This reduction is due to the battery
managment system protecting the RE from high currents which can damage the RE.
15.3. CHARGING YOUR RANGE EXTENDER
„
When charging the RE, use the standard charger and cable supplied with your bicycle to
charge the RE.
„
If you want to charge both the internal battery and the RE at the same time, an optional
Y-splitter cable can be plugged into the charger.
„
Refer to the battery and charger section of this manual for general and safety information
about handling, using, and charging the RE.
CAUTION: Always turn off the bicycle before plugging or unplugging the
charger or RE.
WARNING: The Y-Splitter cable is designed to charge one RE and one internal
battery at the same time.
Do not connect the Y-Splitter cable to two REs or two internal batteries, or
connect more than one Y-Splitter cable to the same charger.
The Y-Splitter cable is available through your Authorized Specialized Retailer.
Please note that Li-ion batteries gradually lose capacity depending on age and
use. Strongly reduced operating time after fully charging can be a sign that
the RE is reaching the end of its useful life and has to be replaced. Provided
the bicycle has been used properly, approximately 75% of the RE’s original
capacity should remain after 300 charging cycles or two years. Replacement
batteries can be purchased from your Authorized Specialized Retailer.
15.4. CHARGE LEVEL DISPLAY WITH RANGE EXTENDER BATTERY
15.8