Specialized KENEVO SL COMP CARBON, Руководство пользователя

Страница: 29 / 51

26
EN
FR
DU
CZ
SK
FREE
FREE
PL
Fig. 10.4
The charge level of the battery is displayed during your ride on the display of the MasterMind
TCU. You can customize your MasterMind TCU to display the charge level in any field on any
page.
At approximately 15 - 20% (depending on cell temperature and other factors) battery charge
remaining, the system will start to reduce the amount of motor support to ensure continuous
assistance at lower charge levels. At 5 - 3%, the system switches off motor support, leaving
the bicycle powered on. This not only supports battery health and lifetime, it also allows you to
keep any wired lights powered for about 2 hours.
The timing of the motor shut-off may slightly vary depending on cell temperature or discharge
scenario (e.g. single vs. parallel discharge).
If your bicycle is at a standstill for 15 minutes or longer, the system will turn itself off to save
power. In order to continue riding with support, you have to turn the system on again.
WARNING! When the battery level has dropped low enough for the motor
system to shut off and the bicycle to go into power-saving mode, wired
lights will be powered only for a limited time, providing some visibility, up to
approximately 2 hours depending on multiple factors. Therefore, you should
stop riding as soon as possible and charge the battery. Lights may shut off at
any time without further warning.
10.5. CLEANING
„
Always turn the battery off and remove the charger from the charge port and wall socket
before cleaning the battery or bicycle.
„
Use a dry or slightly damp cloth for cleaning the battery or bicycle frame. If there is dirt
in or around the charge port, trying using low air pressure or a soft brush to remove it.
For instructions on how to clean drivetrain components, please refer to the drivetrain
manufacturer’s instructions.
„
When cleaning, make sure the charge port on the bicycle is fully closed and no water
comes into contact with the electrical components. If wet, leave the charge port open to
dry out completely before connecting the charger.
„
If your bicycle is fitted with a RE, remove the connector from the charge port and close the
charge port before cleaning.
WARNING! Be careful not to damage or expose electrical components to
water. Do not pressure wash your battery, motor, or any other electrical
components. Damaging electrical components or exposing them to water
may start a fire which can result in serious injury or even death. Do not use or
charge a battery you believe had water seep inside. Likewise, all connectors,
including the charge port, must be completely dry and clean before using or
charging the bicycle.
WARNING: Do not use alcohol, solvents, or abrasive cleaners to clean the
charger. Instead, use a dry or slightly damp cloth.
10.6. STORAGE
WARNING! When the battery is not in use for an extended period of
time, store your battery separately from your bicycle in a dry, cool, and
well-ventilated area. Protect the battery against water and moisture. Before
storing, reduce the charge to approximately 50%. Charge the battery back
up to 50% of charge every three to six months to ensure the battery does
not completely discharge itself which can lead to the battery not being able
to be charged again.
WARNING! Do not leave the charger connected to the bicycle or battery
when storing it.
10.7. TRANSPORT
WARNING! When shipping or transporting the battery over long distances,
including air travel, the charge should be reduced to 50% or less in case
it gets damaged during transit. Package it carefully. Never transport a
damaged battery on an airplane.