Specialized 98122-0001, Инструкция по сборке

Страница: 5 / 22

4
8 9
10 11
12
18
A
13
14 15
CREATE THE BICYCLE ASSEMBLY STAND
8.
Lift the flap on the end of the outer box, push the
inner cutout of the flap toward the inside of the box,
then close the flap inward to create a cradle for the
fork.
9. Remove the bicycle from the packaging, then hang
the fork and down tube in the cradle.
To hold the rear of the bicycle off the
ground, place some extra packaging
under the bottom bracket.
INSTALL THE REAR WHEEL
10. Remove the rear brake pad spacer from the caliper.
CAUTION: Do not pull the brake lever with
the wheel removed and without a brake
pad spacer installed.
If the brake lever is accidentally
pulled and the pads close, refer to the
component manufacturer’s manual for
more information.
11.
Using the corresponding hex key, remove the thru-
axle from the frame and remove the chain protector.
12. Rotate the rear derailleur downward to release the
tension on the chain. If there is a cage lock button
(SRAM)
(A) on the rear derailleur, press it to lock the
derailleur open.
13. Install the rear wheel into the rear frame ensuring
the brake disk is between the brake pads. Place the
chain on the sprocket, then pull the wheel back until
the chain is taut and the wheel is centered.
Ensure the derailleur is in the highest gear
(smallest cog) when inserting the rear
wheel.
14. Lightly grease the shaft of the thru-axle and slide it
through the frame from the left (non-drive side) of
the bicycle.
Do not grease the threads of the
thru-axle.
15. Using a torque wrench and the corresponding hex
bit, tighten the thru-axle (clockwise) to the specified
torque setting found on the axle and/or in the user
manual.
WARNING! A wheel attachment device
that is not properly secured can allow the
wheel to loosen or come off, suddenly
stop the wheel, decrease your control,
and cause you to fall, resulting in serious
personal injury.
For more information on removing and
installing wheels, please refer to the
Owner’s Manual.