Spacelabs 91369, Руководство по обслуживанию

Страница: 121 / 150

91369 Service Manual 5-21
Troubleshooting
7 If the recorder and the associated interface circuitry is good, an error report line is printed upon detection of
an error. LED Error Codes are shown in Table 2 . The error codes may be helpful for determining whether
the error originates from the interconnect board, the recorder CPU, or the OEM recorder module. Refer to
LED D6 in step 6 first; use the printed error code (if available) for possible additional information.
Table 2: Recorder Error Codes
Error Code
(hex)
Failed Assembly or Likely Cause
80 EPROM checksum bad
8F Stack pointer bad
81 Internal RAM will not write all zeroes
82 Internal RAM will not write all ones
83 Timer 0 - No overflow
84 Timer 0 - High byte bad
85 Timer 0 - Low byte bad
86 Timer 1 - No overflow
87 Timer 1 - High byte bad
88 Timer 1 - Low byte bad
30 SDLC Errors - Bad Xmit status
31 SDLC Errors - No SI
32 SDLC Errors - No start flag
33 SDLC Errors - Bad address
34 SDLC Errors - Bad frame type
35 SDLC Errors - No end flag
10 Stuck I/O bus bit 0 low
11 Stuck I/O bus bit 1 low
12 Stuck I/O bus bit 2 low
13 Stuck I/O bus bit 3 low
14 Stuck I/O bus bit 4 low
15 Stuck I/O bus bit 5 low
16 Stuck I/O bus bit 6 low