Spacelabs Healthcare 90217A, Руководство по эксплуатации

Страница: 8 / 46

ABP 90217A Operations Manual
1-2
cuff attached to the patient’s arm. This information is recorded in the monitors and can be
transferred over a modem link or by direct connection between the monitors and one of
the ABP analysis systems.
The monitors can be programmed to either activate or deactivate the following
features:
• Display the cuff pressure at each bleed step.
• Display the systole, diastole, and heart rate at the end of each measurement.
• Bleed to 40 mmHg rather than stopping at the diastolic value.
• Beep before and after each reading.
1.1.1.1 Front Panel
The 90217A monitor front panels include the LCD display, cuff hose connector, and a START/
STOP switch.
1.1.1.2 Rear Panel
The rear panel of the monitor contains program input and output communication ports.
The ON/OFF switch is located on the top panel.
1.2 Replacing the Batteries
Three “AA” batteries provide the main power source for the monitor. These batteries
should be replaced or recharged before the start of each patient monitoring session. Use
either alkaline or rechargeable batteries.
The 90217A monitor backup battery should not require replacement.
1.2.1 Main Battery Replacement
1. Power the monitor OFF, and remove the door over the battery compartment.
2.
Replace the “AA” alkaline or rechargeable batteries, being careful to observe
polarities.
• The monitor will not operate if the batteries are incorrectly installed. If
the monitor is going to be stored for an extended period of time, remove
the batteries to prevent the possibility of leakage or discharge.
• Spacelabs Healthcare is not responsible for product damage incurred
as a result of “AA” battery leakage. In the event your monitor has been
damaged by a leaking battery, contact the battery manufacturer for any
recoverable repair or replacement costs. Spacelabs Healthcare will assist
you in determining those costs.
3. Gently replace the battery cover and secure the latch.