South Bend Tools SB1123, Руководство пользователя

Страница: 62 / 88

-60-
For Machines Mfd. Since 7/21
South Bend Tools
Model SB1123
S E R V I C E
Adjusting Guide Post
Parallelism
The guide post assembly should remain parallel
with the blade front to back and side to side
along its length of travel. If it does not, follow
these instructions to adjust it.
IMPORTANT: Make sure the table is aligned
with the blade from side to side and front to
back before beginning these procedures (refer
to Aligning Table on Page 32 for detailed
instructions).
Tools Needed Qty
Machinist's Square ................................................1
Small Ruler ...........................................................1
Hex Wrench 4, 5, 8mm .................................. 1 Ea.
Checking/Adjusting Guide Post
Parallel with Blade Side to Side
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen guide post lock knob, lower guide
post to within 1" of table top, then tighten
knob.
3.
Place machinist's square on table next to
right-hand side of guide post, as shown in
Figure 95.
Guide Post
(Front View)
Table
Square
Figure 95. Example of checking guide post . Example of checking guide post
squareness. squareness.
5. Loosen jam nut on tension adjustment bolt
7–10 turns (see Figure
94).
6. Rotate quick-release lever to TENSION
position.
7. Turn blade tension handwheel until blade
tension matches mark on blade tension scale
for appropriate blade width.
8. Thread tension adjustment bolt down until it
contacts the wheel block plate, then back it
off 1–2 turns tighten jam nut.
9. Replace wheel, blade (refer to Changing
Blade on Page 43), and close blade covers.
Figure 94. Components for adjusting quick-release lever. Figure 94. Components for adjusting quick-release lever.
Jam Nut Jam Nut
Tension Tension
Adjustment Adjustment
Bolt Bolt
Wheel Block Wheel Block
Plate Plate
!