South Bend Tools SB1123, Руководство пользователя

Страница: 27 / 88

South Bend Tools
For Machines Mfd. Since 7/21 Model SB1123
-25-
P R E P A R A T I O N
Test Run
To test run machine:
1. Clear all setup tools away from machine.
2. Press OFF button.
3. Connect machine to power source.
4. Insert key into Master Power Key Switch,
then rotate switch to "1" position (see
Figure 30). This turns incoming power ON.
5. Twist OFF button clockwise until it springs
out (see Figure
30). This resets switch so
machine can start.
6. Press ON button (see Figure 30) to turn
machine ON. Verify motor starts up
and runs smoothly without any unusual
problems or noises.
7.
Press OFF button to turn machine OFF.
8.
WITHOUT resetting OFF button, try to start
machine by pressing ON button. Machine
should not start.
— If the machine does not start, the safety
feature of the OFF button is working
correctly.
— If the machine does start, immediately
turn it OFF, disconnect power, and
contact customer service for assistance.
The safety feature of the OFF button
is NOT working properly and must
be replaced before further using the
machine.
The test run consists of verifying the following:
• Motor powers up and runs correctly.
• OFF button works correctly.
• Foot brake limit switch works correctly.
• Upper door limit switch works correctly.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine may
result in malfunction or unexpected results
that can lead to serious injury, death, or
machine/property damage.
Serious injury or death can result from using
this machine BEFORE understanding its
controls and related safety information. DO
NOT operate, or allow others to operate,
machine until the information is understood.
After all preparation steps have been completed,
the machine and its safety features must be
tested to ensure correct operation. If you discover
a problem with the operation of the machine or
its safety components, do not operate it further
until you have resolved the problem.
Note:
Refer to Troubleshooting on Page 68
for solutions to common problems. If you need
additional help, contact our Tech Support at
(360) 734-1540.
Figure 30. Location of power controls for turning Location of power controls for turning
machine machine
ON ON
and and
OFF OFF
..
Master Power Master Power
Key Switch Key Switch
ON Button ON Button
OFF
Button