South Bend Tools SB1123, Руководство пользователя

Страница: 38 / 88

OPERATION
-36-
For Machines Mfd. Since 7/21
South Bend Tools
Model SB1123
O P E R A T I O N
Operation Overview
To complete a typical operation, the operator
does the following:
1. Examines the workpiece to make sure it is
suitable for cutting.
2. Adjusts table tilt, if necessary, to correct
angle of desired cut.
3. If using fence, adjusts it for width of cut and
then locks it in place. If using miter gauge,
adjusts angle and locks it in place.
4. Loosens guide post lock knob, adjusts upper
blade guide height to just clear the workpiece
(no more than
1
⁄
4
" above workpiece), then
retightens guide post lock knob.
5. Checks to make sure workpiece can safely
pass all the way through blade without
interference from other objects.
6. Puts on safety glasses and respirator.
7. Starts dust collector, then starts bandsaw.
8. Holds workpiece firmly and flatly against
both table and fence (or miter gauge), and
then pushes workpiece into blade at a steady
and controlled rate until cut is complete.
Operator is very careful to keep fingers away
from blade and uses a push stick to feed
narrow workpieces.
9. Stops bandsaw.
To reduce the risk of
serious injury when using
this machine, read and
understand this entire
manual before beginning
any operations.
The purpose of this overview is to provide
the novice machine operator with a basic
understanding of how the machine is used during
operation, so they can more easily understand
the controls discussed later in this manual.
Note: Due to the generic nature of this overview,
it is not intended to be an instructional guide for
performing actual machine operations. To learn
more about specifi c operations and machining
techniques, seek training from people experienced
with this type of machine, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
Untrained users have an increased risk
of seriously injuring themselves with this
machine. Do not operate this machine until
you have understood this entire manual and
received proper training.
To reduce risk of eye injury
from flying chips or lung
damage from breathing dust,
always wear safety glasses
and a respirator when
operating this machine.