© 2000-2018 SOTA Instruments Inc.
Page 10 of 13
|
www.sota.com
The Silver Pulser Model ZBB4 Manual
Drink Plenty of Water:
It’s important to drink enough water when using the unit.
Drinking ozonated water is especially helpful.
Stop Gradually:
Reduce the amount of time each day for the last week of use. If
using the 4-part SOTA Protocol, it is suggested to stop only one part of the protocol
at a time.
HOW TO USE THE IONIC~COLLOIDAL SILVER FUNCTION
HOW TO ASSEMBLE
1.
The Silver Wires fit into the two small holes in the Silver
Wire Holder.
2. To insert the Silver Wires, move the spring clip away
from the hole to allow the wire to slide in smoothly.
a. Insert as in the picture. Push the wire through. Most
of the wire should be below the holder. It may be
easier to insert from the underside of the holder.
b. Release the clip to hold the Silver Wire snuggly in
place.
3. Repeat the above steps for the second Silver Wire and plug the Silver Wire Holder
into the Silver Pulser.
HOW TO MAKE IONIC~COLLOIDAL SILVER
1. Heat 2 cups (500 ml) of distilled water to the boiling
point—preferably in a non–metal container. Do not
use a glass measuring cup on the stove top as it may
explode.
2. Use a heat-resistant glass container to make
Ionic~Colloidal Silver.
3. Place the Silver Wire Holder on the glass container
immersing the Silver Wires. Keep them at least 25 mm
or 1 inch from the bottom of the container.
4. Turn the unit ON by rotating the thumbwheel switch
clockwise, until it clicks. It is not necessary to turn up
the intensity.
When the Silver Wire Holder is plugged into the unit, the GREEN light on the