© 2000-2018 SOTA Instruments Inc.
Page 6 of 13
|
www.sota.com
The Silver Pulser Model ZBB4 Manual
HOW TO USE THE MICROPULSING FUNCTION
1. Place the 9-Volt Alkaline battery in the unit.
a. On the back of the unit, slide off the battery cover.
b. Attach the positive (+) and negative (-) terminals on the 9-Volt Alkaline battery to
the positive (+) and negative (-) clips in the battery compartment.
c. Slide the 9-Volt Alkaline battery into the case and push down. Slide the cover back
onto the unit.
2. Clean the wrist area to remove oils from the skin. This will allow for better
conductivity.
3. Insert the Micropulsing Cord into the jack on the unit.
4. Slide the unit into the arm strap.
5. Slide the unit and the Cord up the arm to a comfortable position. Tighten the band to
secure it in place.
Option: If preferred, the unit can be placed in a pocket. A longer Micropulsing Cord
is needed for this option.
ALL COTTON SLEEVES OPTION
6. Prepare one pair of Cotton Sleeves. Each Cotton Sleeve is
sewn on three sides; to find the open end of the Cotton
Sleeve, squeeze the long sides of the sleeve and the unsewn
end will pop open.
7. Insert one probe from the Micropulsing Cord into the open
end of each Cotton Sleeve. Use a gentle twisting motion to
work the probes into the Cotton Sleeves.
8. Wet the Cotton Sleeves with water.
9. Put the Wrist Strap on.
10. Position one of the covered probes over the pulse point on
the thumb side of the wrist, under the Wrist Strap.
11.
Place the other covered probe in line with the pulse point on the little finger side of
the wrist. This pulse point is usually harder to feel. It is located in the soft hollow
on the wrist, in line with the little finger.
1