© 2000-2018 SOTA Instruments Inc.
Page 7 of 13
|
www.sota.com
The Silver Pulser Model ZBB4 Manual
COTTON SLEEVES WITH VELCRO
®
OPTION
6. Put the Wrist Strap on with the Velcro
®
side of the Wrist
Strap face-out rather than towards the skin.
Prepare one pair of Cotton Sleeves. Each Cotton Sleeve
is sewn on three sides; to find the open end of the Cotton
Sleeve, squeeze the long sides of the sleeve and the unsewn
end will pop open.
7. Attach one Cotton Sleeve to the Wrist Strap in line with
the pulse point on the thumb side of the wrist. The open end
of the Cotton Sleeve will point down toward the elbow. Press
the sleeve to the Wrist Strap to firmly adhere the sleeve in
place.
Place the other Cotton Sleeve, again with the open side
towards the elbow, in line with the pulse point on the little finger side of the wrist.
This pulse point is usually harder to feel. It is located in the soft hollow on the wrist,
in line with the little finger. Press the sleeve to the Wrist Strap to firmly adhere the
sleeve in place. See image 2.
Once in place, the Velcro
®
will hold the Cotton Sleeves in the right position for
repeated use.
8. Take the Wrist Strap off.
9. Insert one probe from the Micropulsing Cord into each of the Cotton Sleeves. Use a
gentle twisting motion to work the probes into the Cotton Sleeves.
10. Wet the Cotton Sleeves with water.
11. Put the Wrist Strap on so the damp Cotton Sleeves are against the skin over the
pulse points. See image 1.
TURNING THE UNIT ON
12. Turn the unit ON by rotating the thumbwheel switch clockwise. Turn the switch
slowly until you feel the current. If you do not feel the current, see Notes below.
When the Micropulsing Cord is plugged into the unit, the flashing
GREEN and
RED lights will not be on. This helps conserve the battery.
13.
When finished, turn unit OFF by rotating the thumbwheel switch fully counter-
clockwise until it clicks. Do not force the ON/OFF knob past its natural stopping
point.
2