Sortimo ProCargo CT1, Руководство по эксплуатации

Страница: 7 / 33

12 13
2.1. Adjusting the saddle height
The saddle height is a decisive influential factor on efficiency of the power you
exert on the pedelec.
Saddle height is correct when your leg is almost
straight with the ball of your foot on the pedal.
The crank arms are thereby aligned vertically.
Block the tilting system when checking the
saddle height to prevent toppling.
To change the saddle height, proceed as follows:
• Continue to loosen the seatpost clam-
ping screw with an Allen key until it is
possible to adjust the saddle height.
• Then tighten the screw with a torque of
5-7 Nm using the Allen key.
The seatpost clamping screw is tightened sufficiently when the seatpost
can not be turned or when it no longer slides down into the seat tube
under your weight.
If you pull the seatpost out too far, the
upper part of the seat tube may sustain
damage which could lead to breakage.
There is a risk of accident or injury!
-> Pull out the seatpost until the
marking for minimum insertion depth
is only just visible.
2.2. Adjusting handlebar height
The ProCargo CT1 is equipped with a stem adjustable in height. In the delivery
condition, the stem is screwed into its lowermost position (-20°). The height of the
stem can be increased by up to 11.5 cm by adjusting the angle of the stem
(max. angle 60°). To adjust the height of the stem, proceed as follows:
• Continue to loosen both screws marked
in red until it is possible to turn the
stem.
• Set the desired angle and note the
difference in angle.
• Tighten the screws marked in red once
again with 14-15 Nm.
In the second step, the handlebar must also be
turned around this difference in angle in the
opposite direction, indicated by the right-hand
semicircular arrow:
• Loosen all 4 screws on the clamping plate of the stem until it is possible
to turn the handlebar.
• Turn the handlebar around the difference in angle opposite to that noted.
• Retighten all 4 handlebar clamping screws of the stem with 6 Nm.
2.3. Removing/installing the battery
Removing the battery:
• Ensure that the system is switched off.
• Turn the key around a quarter of a turn
in the lock while at the same time tipping
the battery out of the upper holder.
• Lift the battery out of the holder.
Installing the battery:
• Place the battery with the contacts on the lower holder and tilt it into the
• upper holder so that it clicks into place.
Initial set-up Initial set-up