SORIN GROUP S5 System, Инструкция по эксплуатации

Страница: 103 / 191

S5 System • Replacing components
SM-5811-0000.01 ENG 6.19
For further disassembly of the RP 150:
◗
If it has not already been done: Remove the pump cover from the pump head.
◗
Carefully place the pump head down on a soft, flat work surface. Take care not to scratch the pump
head.
◗
Disconnect the connector B 22 from the circuit board Motor power amplifier B 13 .
◗
Loosen the indicated screw (allen key size 2.5 mm) including the washer, in order to separate the
bracket with the cable B 48 from the circuit board.
◗
Loosen the indicated screws (allen key size 2.5 mm) including the spring washers and the
distance bolts.
◗
Carefully lift up the circuit board B 13 .
◗
In order to separate the Motor controller B 14 circuit board from the pump head, loosen the four
distance bolts from the circuit board.
No further dismantling of the roller pump is planned. Each of the three units
–
Motor controller circuit board,
– Motor power amplifier circuit board and
– Pump head (10-81-00)
is to be replaced as a complete unit.
!
When reassembling (in reverse order) thereafter be extremely careful in positioning the individual
components. Screw the fasteners on the circuit boards in cross pattern and in several iterations in order
to ensure a level seat.
Take care to avoid bending the pins of the connectors.
Assembly material
a Socket head screw DIN 912 M3x6
b Washer DIN 125 A 3.2
c
Cable clip
CC S 31
d Spring washer DIN 127 B4
e Distance bolts with internal/external thread M3 x 15 (WAF 5.5 mm)
f Distance bolts with internal/external thread M3 x 7 (WAF 5.5 mm)