Troubleshooting Your Computer
My computer does not start.
Make sure the computer is plugged into a power source and is turned on.
Make sure the power indicator shows the power is on.
Make sure the battery packs are inserted properly and are charged.
If you are connected to a docking station with a floppy disk drive or an external floppy disk drive, make sure the
floppy disk drive is empty.
Make sure the power cord and all cables are connected firmly. See "Connecting a Power Source" for more
information.
If the computer is plugged into a power strip or uninterruptible power supply (UPS), make sure the power strip or
UPS is turned on and working.
If you are using an external display, make sure it is plugged into a power source and turned on. Make sure the
brightness and contrast controls are adjusted correctly. See the manual that came with your display for details.
Take the battery pack off the computer, unplug the power cord and plug it in again. Turn on the power.
If the power control button does not function, remove the AC adapter and battery pack. Wait one minute, and
reattach them. Press the power button.
Condensation may cause the computer to malfunction. If this occurs, do not use the computer for at least one hour.
Unplug the power cord, press the reset button by using a thin, straight object (such as a paper clip), remove the
battery pack, plug it in again and turn on the power.
Page 126
Содержание PCG-SRX87 VAIO User Guide (primary manual)
