How to connect a phone cable
1.
Open the phone line jack cover, located on the left side of the computer near the front.
Use care when opening the phone jack cover. Opening it too far may result in damage to the unit.
Opening Phone Line Jack Cov er
2.
Plug one end of the phone cable into the jack on the inside of the phone line jack cover. Make sure you insert
the phone cable from the rear of the computer and that the modular jack clicks into place.
3.
Plug the other end into the wall jack.
Plugging in Phone Cable
Your computer does not work with party lines, cannot be connected to a coin-operated telephone, and may not
work with multiple phone lines or a private branch exchange (PBX). Some of these connections may result in excess
electrical current and could cause a malfunction in the internal modem.
If you connect a phone line coming through a splitter, the modem or connected device may not work properly.
Page 31
Содержание PCG-SRX87 VAIO User Guide (primary manual)
