Sony IFB-LE100, Руководство по обслуживанию

Страница: 32 / 258

1-26
VPD-LE100A/LE100E/LE100U
6
Location and Function of Controls
Location and Function of Controls
Front
1 Front ventilation holes (intake)
2
Lens mount part
When attaching the optional lens, consult with
qualified Sony personnel.
3
Carrying handle
Pull out the handle for carrying the projector.
4 Front ventilation holes (under the lens, intake)
5 Handle release buttons
Press the two buttons simultaneously for putting away
the carrying handle.
6 AC inlet
Connect the supplied AC power cord.
For the connection of the AC power cord, see page 7.
7 POWER switch
Turn on/off the main power of the projector.
8 Front remote control (SIRCS) detector
9 Adjusters
Use the adjusters to keep the projector level if it is
installed on an uneven surface.
q; Left side ventilation holes (exhaust)
qa
Left side ventilation holes (intake)
qs Control panel
For details, see page 8.
qd Right side ventilation holes (intake)
About the ventilation holes
Caution
• Do not block the ventilation holes (intake and
exhaust), or internal heat build-up may occur, causing
fire or damage to the projector.
• Do not place anything near the ventilation holes
(exhaust) or touch these holes as the temperature will
be very high.
1
2
3
4
6 7 8
9
q;
qa
qs
qd
5
7
Location and Function of Controls
To put away the handles
To put away the front handle, press the two handle
release buttons beside the left and right feet of the
handle simultaneously.
To put away the rear handle, lower it.
Using the adjusters
When the projector installation location is not
horizontal, rotate the adjusters using the supplied tool
so that the projector is placed horizontally. There are
four adjusters.
Note
The supplied tool can rotate the adjuster screw in one
direction only. To rotate the screw in the reverse
direction, turn the tool upside down.
Caution
Do not turn the tool forcibly when the screw has fully
rotated. Otherwise, the tool may slip out and injure
your hand.
Preparations
Connecting the AC power cord
1
Press the lower part of the AC inlet cover ring to
remove it.
2
Pass the supplied AC power cord through the ring.
3
Insert the plug of the AC power cord into the AC
inlet, aligning the indent of the plug with the
projection of the inlet, then tighten the screw on
the plug.
4
Replace the AC inlet cover ring.
Using the carrying handles
Use the front and rear carrying handles to carry the
projector.
Caution
To avoid injury, have at least four people carry the
projector using the front and rear handles.
AC inlet
cover ring
Press the lower part.
Pull out.
Pull up.
Supplied tool
Supplied tool
To lower To raise
Projection
Handle release
button