Sony HVR-M10C, Руководство по обслуживанию

Страница: 273 / 329

Chapter 3 Dubbing/Editing
Chapter 3 Dubbing/Editing
35
Rear view of the player
(this unit)
Monitor
i.LINK cable (not supplied)
i.LINK jack
Digital video
equipment with an
i.LINK jack
: Signal flow
Monitor
(Continued)
Chapter
3
Dubbing/Editing
Dubbing to another equipment
This section describes the connections and settings
necessary to perform dubbing on other equipment,
using this unit as a video player.
Connections for Dubbing
Notes
• For connection of the editing controller and its
peripheral devices, refer to the instruction manual of
the editing controller and that of the editing software
you use.
• Edit functions are specified by the editing software.
For details on the editing methods, refer to the
instruction manual of the editing software.
• You cannot use the DSR-25/45-equipped duplicate
function to dub a tape recorded in HDV/DV format
via the i.LINK connection. Use the procedure in this
chapter to perform dubbing.
To digital video equipment with an i.LINK
jack
Connect this unit to the recorder as shown below using
an i.LINK cable.
The signal flow is automatically detected so you do not
need to make separate connections for input and
output. Also, connecting the unit to an editing
controller via HDV/DV jacks, you can configure a
digital non-linear editing system.
For connections of the editing controller and this unit, refer
to the editing controller instruction manual.
Before dubbing, you must set the format in which you
want to output signals. Perform the [VCR HDV/DV]
(p. 48) and [i.LINK CONV] (p. 49) settings of the [IN/
OUT REC] menu.
For details, refer to “Compatibility of HDV, DVCAM, and
DV Formats” (p. 68).